F34Serious
Kenmore Washer F34 Error Code
The pressure switch circuit is open, meaning the control board cannot read water level signal.
Common causes
- Loose or disconnected pressure switch harness
- Faulty pressure switch
- Broken wire in the harness
How to fix it
- Unplug the washer. Check the wire harness connector at the pressure switch for secure connection.
- Inspect the wires for cuts or damage from rubbing against the chassis.
⚠ When to call a pro: If the connector is secure and wires look good, the pressure switch or control board may be defective. Call a pro.
Part links are affiliate links — as an Amazon Associate we may earn a small commission at no extra cost to you.
Always unplug the appliance (and turn off the water for washers/dishwashers) before inspecting. These guides are for information only and are not a substitute for a professional repair.