i70Warning
Electrolux Dishwasher i70 Error Code
The temperature sensor (NTC) is sending an out-of-range reading to the controller.
Common causes
- Loose or corroded sensor connector
- Defective NTC sensor
- Water ingress into the sensor assembly
How to fix it
- Check the sensor connector at the sump for tightness and corrosion.
- Measure the sensor resistance at room temperature (should be ~10k ohms).
- If resistance is far off, replace the NTC sensor.
⚠ When to call a pro: If replacing the sensor doesn't clear the code, the control board may be faulty.
Part links are affiliate links — as an Amazon Associate we may earn a small commission at no extra cost to you.
Always unplug the appliance (and turn off the water for washers/dishwashers) before inspecting. These guides are for information only and are not a substitute for a professional repair.