F13Warning
Kenmore Oven/Range F13 Error Code
The oven temperature is too far from the set point after a calibration cycle.
Common causes
- Oven temperature sensor out of range
- Defective control board
- Misaligned oven door causing heat loss
How to fix it
- Unplug the range for 30 seconds to reset
- Check that the oven door seals properly
- If code returns, test the oven sensor as in F11 steps
⚠ When to call a pro: If sensor tests good and door seals well, the control board may need replacement; call a technician.
Part links are affiliate links — as an Amazon Associate we may earn a small commission at no extra cost to you.
Always unplug the appliance (and turn off the water for washers/dishwashers) before inspecting. These guides are for information only and are not a substitute for a professional repair.