F9E1Serious
Maytag Dishwasher F9E1 Error Code
Too much water entered the tub. May cause leak or flooding.
Common causes
- Stuck water inlet valve (fails open)
- Faulty float switch
- Control board stuck relay
- Clogged sump preventing drainage
How to fix it
- Turn off power and water supply immediately.
- Manually drain water using a sponge or hose.
- Check float switch for free movement; clean if stuck.
- Inspect water inlet valve for debris holding it open.
⚠ When to call a pro: If water continues to fill after power off, inlet valve is mechanically stuck and must be replaced.
Part links are affiliate links — as an Amazon Associate we may earn a small commission at no extra cost to you.
Always unplug the appliance (and turn off the water for washers/dishwashers) before inspecting. These guides are for information only and are not a substitute for a professional repair.